Page 5
Page 5
Page 5
Page 5
Page 5
CISSELL
CISSELL
CISSELL
CISSELL
CISSELL
GARMENT MANUFACTURERS FORMS
GARMENT MANUFACTURERS FORMS
GARMENT MANUFACTURERS FORMS
GARMENT MANUFACTURERS FORMS
GARMENT MANUFACTURERS FORMS
GENERAL INFORMA
GENERAL INFORMA
GENERAL INFORMA
GENERAL INFORMA
GENERAL INFORMATION
TION
TION
TION
TION
INSTALLATION INSTRUCTIONS (REFER TO ILLUSTRATION SHEET)
UNCRATE MACHINE. Check voltage and current on name plate before installing
machine. Electrical specification of relays, timers and motor solenoids must be the
same. Do not remove the plastic protective cover on the form until the machine is
ready to be placed in operation.
SET MACHINE IN POSITION. Grip a control knob and the turning knob and lift
revolving form assembly about 22” to remove from base.
CONNECT STEAM SUPPLY LINE. This line must fall towards the macnine (without
water pockets). Connect to steam supply line with union, gate valve and 12” or more
riser. If finisher is located near end of steam line, install a by-pass trap and check
valve as illustrated in dotted lines.
CONNECT RETURN LINE. This line must fall towards boiler (without water pockets).
Connect to steam return line with unions, strainer, steam trap, and 12” or more riser.
Inspect trap carefully for inlet and outlet markings. Install trap as near the machine
as possible, and lower than the return line outlet on the machine.
NOTE:
A check valve is not required for a thermodynamic trap. A check
valve is required with an impulse trap.
Use a Sarco or Yarway Thermo-dynamic Trap, Impulse trap or
equal in the return line of the machine. Do not use a bucket
trap unless its size will permit installation below the return line
outlet of the machine.
IMPORTANT: Before making final connection to return line, open gate valve in steam
supply line and flush pipe dope, borings, and all other foreign matter from the steam
connections and steam chamber. Failure to do so will cause trap troubles.
