Page 13
Page 13
Page 13
Page 13
Page 13
NO
NO
NO
NO
NOTES
TES
TES
TES
TES
When sizing the form always operate the levers in a right to left sequence (Waist-Hem-
Lower). When pulling the form “in” to start resizing, always operate the levers in a left
to right sequence (Lower-Hem-Waist). The levers can not be pushed forward (toward
the form) when the bag is inflated.
A water spray gun is provided to add moisture when needed for difficult wrinkles in
hard fabrics. Spray garment where needed DURING THE STEAMING CYCLE hold-
ing the spray gun about 15” from garment and allowing mist to FALL INTO THE
STEAM and onto the fabric.
Collars and various trim may be finished during the normal cycle by wiping with a
hand pad before the garment is dry.
Always reduce form to its smallest size before starting the sizing operation.
IMPORT
IMPORT
IMPORT
IMPORT
IMPORTANT!
ANT!
ANT!
ANT!
ANT!
For maximum production always finish as many garments of the same size and style as
possible at the same time. This avoids unnecessary adjustments and improved overall
machine performance.
Place garments on a rack, front upward, so they are convenient to the form operator,
with the hem toward the operator. The operator can then easily grab the hem, and
with a single sweeping motion partially fill it with air so it will be extended and drop
easily over the form, failing completely down so the hem will be straight.
When using the bag sleeves, a garment is best removed from the form by holding the
garment sleeves at the UNDER side and lifting upward. The bag sleeves will easily
slip out of the garment.
