Page 9
Page 9
Page 9
Page 9
Page 9
OPERA
OPERA
OPERA
OPERA
OPERATING INSTRUCTIONS FOR
TING INSTRUCTIONS FOR
TING INSTRUCTIONS FOR
TING INSTRUCTIONS FOR
TING INSTRUCTIONS FOR
CISSELL FMFC
CISSELL FMFC
CISSELL FMFC
CISSELL FMFC
CISSELL FMFC AND FMJC FORM FINISHER
AND FMJC FORM FINISHER
AND FMJC FORM FINISHER
AND FMJC FORM FINISHER
AND FMJC FORM FINISHER
(See drawing on next page)
STEAM TIMER - Set Timer for required cycle. Located on the control panel (front of the blower
housing). Turn the small knob on the timer face until the pointer indicates the desired time setting.
Turn the knob only when the machine is not in an automatic cycle.
FOR LIGHT SYNTHETIC FABRICS, a time setting of 3 to 4 seconds is normally adequate. For
heavier, more absorbant fabrics increase the time setting until a good finish is obtained.
NOTE: Avoid over-steaming. Over-steaming may shrink stitching, require a longer drying time,
cause condensation and slow production. The minimum steam that will give the desired finish is best.
1.
AIR TIMER - Set Timer for required cycle. Located on the control panel (front of the blower
housing). Turn the small knob on the timer face until the pointer indicates the desired time setting.
Turn the knob only when the machine is not in an automatic cycle.
FOR LIGHT SYNTHETIC FABRICS, a time setting of 4 to 5 seconds with SEPARATE Steam-Air or
7 to 9 seconds with “”MIXED” Steam-Air is normally adequate. For heavier fabrics that retain more
moisture, increase the air time until the garment is properly cured.
2
SET PRESSURE CONTROL lever “A” at minimum position.
3
PUSH FAN MOTOR SWITCH to “ON” position. Located on the control panel (front of the blower
housing). Blower will start and run continuously and control circuits will be energized. Machine
can be operated automatically or manually. To de-energize the entire machine, push selector switch
to “OFF”.
4
POSITION GARMENT on form and adjust shoulders (knob on top of form).
5
PUSH MANUAL AIR OVERRIDE SWITCH to “ON” position. Located on the push button box.
When the Fan Motor switch is turned “ON” and the bag inflates and remains inflated, move the air
override selector to its opposite position.
6
PUSH PRESSURE CONTROL LEVER “A” toward maximum until bag comes within 1/4” of filling
hemline of garment.
7
RETURN MANUAL AIR OVERRIDE SWITCH to “OFF” position.
8
PRESS AUTOMATIC START BUTTON - Located on the movable pipe column supported on the
blower housing. This button or the FOOT PEDAL SWITCH is pressed momentarily to start the
automatic cycle. This can be operated from either side of machine. (by swinging column.)
9
REPEAT STEPS 2, 4, 6, 7 and 8 when changing size and/or styles.
10 STEAM AIR SWITCH - Located on the control panel (front of the blower housing). For automatic
sequence of STEAM WITHOUT AIR FOLLOWED BY AIR, push switch to “SEPARATE” position.
For automatic sequence of STEAM AND AIR MIXED (simultaneous start) followed by AIR ONLY,
push switch to “MIXED” position. Determine the best setting for each fabric by test. When using
STEAM AND AIR MIXED the air time should be doubled; Example -
Steam - Air - Total
4 sec.
8 sec. 8 sec.
