Cisco WAVE-574-K9 - Wide Area Virtualization Engine 574, Hardware Installation Manual

Page: 90 / 112

Chapter 6 Troubleshooting the System Hardware
Power-On Self Test (POST)
6-20
Cisco Wide Area Virtualization Engine 574 Hardware Installation Guide
OL-17738-01
REDUNDANT ROM ERROR: Bootblock Invalid. - ...
...contact Your Representative.
Possible Cause: ROM bootblock is corrupt.
Action: If the problem persists, contact the Cisco Technical Assistance Center.
REDUNDANT ROM ERROR: Primary ROM invalid. Booting Backup ROM. -...
...run ROMPAQ to correct error condition
Possible Cause: The primary system ROM is corrupt. The system is booting from
the redundant ROM.
Action: If the problem persists, contact the Cisco Technical Assistance Center.
Temperature violation detected - system Shutting Down in x seconds
Possible Cause: The system has reached a cautionary temperature level and is
shutting down in X seconds.
Action: Adjust the ambient temperature and check the fans. If the problem
persists, contact the Cisco Technical Assistance Center.
There must be a first DIMM in pair if second DIMM in pair is populated. Second DIMM in pair ignored.
Description: The first DIMM socket in the pair is not populated. The second
DIMM in the pair is not recognized or used.
Action: Be sure the memory is installed correctly. Use only Cisco DIMM pairs
when populating memory sockets. See the
“Installing Memory” section on
page 4-8 . If the problem persists, contact the Cisco Technical Assistance Center.
This system only supports 667 MHz Front Side Bus Speed Processors. One or more 800 MHz Front Side Bus
Speed Processors have been initialized at 667 MHz. System Halted!
Possible cause: One or more 800-MHz front side bus speed processors have been
initialized at 667-MHz.
Action: If the problem persists, contact the Cisco Technical Assistance Center.
Unsupported DIMM(s) found in system. - DIMM(s) may not be used
Description: Unsupported memory types found in system.