Cisco WAVE-574-K9 - Wide Area Virtualization Engine 574, Hardware Installation Manual

Page: 88 / 112

Chapter 6 Troubleshooting the System Hardware
Power-On Self Test (POST)
6-18
Cisco Wide Area Virtualization Engine 574 Hardware Installation Guide
OL-17738-01
Action: Enter a valid password with the correct permissions.
Memory found on unpopulated Node. — Processor is required to be installed for memory to be used.
Description: The system detects DIMMs, but is unable to use the DIMMs because
a processor is not installed in the corresponding socket.
Action: Be sure the memory is installed correctly. Use only Cisco DIMM pairs
when populating memory sockets. See the
“Installing Memory” section on
page 4-8 . If the problem persists, contact the Cisco Technical Assistance Center.
Mixed processor speeds detected. Please make sure that all processors are the same speed. — System
Halted!
Description: Mixed processor speeds are not supported.
Action: Refer to the WAVE appliance documentation for supported processors. If
the problem persists, contact the Cisco Technical Assistance Center.
Network Server Mode Active and No Keyboard Attached
Possible Cause: A keyboard is not connected. An error has not occurred, but a
message is displayed to indicate the keyboard status.
Action: No action is required.
NMI - Button Pressed!
Possible Cause: The NMI button was pressed, initiating a memory dump for crash
dump analysis.
Action: Reboot the WAVE appliance.
NMI - Undetermined Source
Possible Cause: An NMI event has occurred.
Action: Reboot the WAVE appliance.
Node Interleaving disabled - Invalid memory configuration
Description: Each node must have the same memory configuration to enable
interleaving.