Cisco WAVE-574-K9 - Wide Area Virtualization Engine 574, Hardware Installation Manual

Page: 46 / 112

Chapter 3 Installing the WAVE-574
Connecting Power and Booting the System
3-4
Cisco Wide Area Virtualization Engine 574 Hardware Installation Guide
OL-17738-01
Figure 3-1 Cable Connections
Connecting Power and Booting the System
To connect power to your system, follow these steps:
Step 1
Review the information in the “Safety Guidelines” section on page 2-3 .
Step 2
Plug a power cord into the power cord receptacle on the back of the WAVE
appliance.
Step 3
Connect the other end of the power cord to a power source at your installation site.
Step 4
Power up all externally connected devices.
Step 5
Press the power control button on the front of the WAVE appliance.
The system should begin booting. Once the operating system boots, you are ready
to initialize the basic software configuration. (See the software configuration
guide for details.)
1 Power cord connector 3 Console port (serial connector)
2
10/100/1000 NIC 2 connector
4
10/100/1000 NIC 1 connector