The console displays a set of parameters. You must enter the parameters as described in the following table
Table 1: Cisco ISE Setup Program Parameters
Example
Description
Prompt
isebeta1
Must not exceed 15 characters. Valid characters include
alphanumerical (A
–
Z, a
–
z, 0
–
9), and the hyphen (-). The first
character must be a letter.
We recommend that you use lowercase letters to ensure
that certificate authentication in Cisco ISE is not impacted
by minor differences in certificate-driven verifications.
You cannot use "localhost" as hostname for a node.
Note
Hostname
10.12.13.14
Must be a valid IPv4 address for the Gigabit Ethernet 0 (eth0)
interface.
(eth0) Ethernet
interface address
255.255.255.0
Must be a valid IPv4 netmask.
Netmask
10.12.13.1
Must be a valid IPv4 address for the default gateway.
Default gateway
example.com
Cannot be an IP address. Valid characters include ASCII
characters, any numerals, the hyphen (-), and the period (.).
DNS domain
name
10.15.20.25
Must be a valid IPv4 address for the primary name server.
Primary name
server
(Optional) Allows you to
configure multiple name
servers. To do so, enter y to
continue.
Must be a valid IPv4 address for an additional name server.
Add/Edit another
name server
clock.nist.gov
Must be a valid IPv4 address or hostname of a Network Time
Protocol (NTP) server.
Primary NTP
server
(Optional) Allows you to
configure multiple NTP
servers. To do so, enter y to
continue.
Must be a valid NTP domain.
Add/Edit another
NTP server
Cisco Identity Services Engine Hardware Installation Guide, Release 2.0.1
36
Install Cisco ISE Software on the SNS 3515 and SNS 3595 Appliances
Install the ISE Server
