Power Specifications
The power specifications for the power supply options are listed in the following section:
Do not mix power supply types in the server. Both power supplies must be identical.
Note
770-WAC Power Supply
Specification
Description
90 to 264 VAC (self-ranging, 100 to 264 VAC
nominal)
AC input voltage range
Range: 47 to 63 Hz (single phase, 50 to 60 Hz
nominal)
AC input frequency
9.5 A peak at 100 VAC
4.5 A peak at 208 VAC
AC line input current (steady state)
770 W
Maximum output power for each power supply
Main power: 12 VDC
Standby power: 12 VDC
Power supply output voltage
Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware
Appliances
This section describes how to install your Cisco SNS 3515 or 3595 appliance and connect it to the network.
It contains:
•
Install the Cisco SNS 3515 or 3595 Appliance in a Rack, on page 16
•
Cisco Integrated Management Controller, on page 27
•
Connect Cables, on page 21
•
Connect and Power On the Cisco SNS 3515 or 3595 Appliance, on page 25
Before you begin the installation, read the
Regulatory Compliance and Safety Information for the Cisco SNS
3515 or Cisco SNS 3595 Hardware Appliance
.
Warning: Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning: This unit is intended for installation in restricted access areas. A restricted access area can be accessed
only through the use of a special tool, lock and key, or other means of security.
Cisco Identity Services Engine Hardware Installation Guide, Release 2.0.1
15
Install Cisco ISE Software on the SNS 3515 and SNS 3595 Appliances
Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware Appliances
