2-14
Cisco Physical Access Gateway User Guide
OL-32499-01
Chapter 2 Installing and Configuring the Cisco Physical Access Gateway
Installing the Cisco Physical Access Gateway
Step 7
Connect the Gateway to the IP network by connecting an Ethernet cable to the ETH0 port, as shown in
Figure 2-11
.
Figure 2-11
ETH 0 Ethernet Connection for the Cisco Physical Access Gateway
Step 8
Continue to the
“Configuring the Gateway Using the Cisco Physical Access Manager” section on
page 2-24
.
1
ETH0—Ethernet port for connecting the Gateway to the IP network.
Note
The ETH0 connection can also be used for Power over Ethernet.
Note
The ETH1 port is used to connect a PC to the Gateway for configuration and monitoring.
See the
“Configuring and Managing the Gateway Using a Direct Connection” section on
page 2-15
for more information.
271591
1