Cisco Nexus 7000 Series, Command Reference Manual

Page: 460 / 1018

ipv6 access-class
To apply an IPv6 access control list (ACL) to a virtual terminal (VTY) line, use the access-class command.
To remove an IPv6 ACL from a VTY line, use the no form of this command.
ipv6 access-class access-list-name { in| out }
no ipv6 access-class access-list-name
{
in| out
}
Syntax Description
Name of the IPv6 ACL. access-list-name
(Optional) Specifies that the device applies the ACL
to inbound traffic. in
(Optional) Specifies that the device applies the ACL
to outbound traffic. out
Command Default
None
Command Modes
Line configuration
Command History
Modification Release
This command was introduced. 4.0(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to remove dynamically learned, secure MAC addresses from the Ethernet 2/1
interface:
switch# configure terminal
switch(config)#
line vty
switch(config-line)# ipv6 access-class acl-ipv6-vty01
Related Commands
Description Command
Configures an IPv6 ACL. ipv6 access-list
Configures line access to the device. line
Cisco Nexus 7000 Series Security Command Reference
434
I Commands
ipv6 access-class