174
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
ip offset-list eigrp
ip offset-list eigrp
To configure an offset list for the Enhanced Interior Gateway Routing Protocol (EIGRP) on an interface,
use the
ip offset-list eigrp
command. To restore the default, use the
no
form of this command.
ip offset-list eigrp
instance-tag
{
prefix-list
list-name
|
route-map
map-name
} {
in
|
out
}
offset
no ip offset-list eigrp
instance-tag
{
prefix-list
list-name
|
route-map
map-name
} {
in
|
out
}
offset
Syntax Description
Command Default
None
Command Modes
Interface configuration mode
Command History
Usage Guidelines
Cisco NX-OS adds the configured offset value to any routes that match the configure prefix list or route
map. You must configure the named route map or prefix list to complete this configuration.
This command requires the LAN Base Services license.
Examples
This example shows how to configure an offset list filter to add 20 to the metric for EIGRP routes coming
into the interface that match the route map OffsetFilter:
switch#
configure terminal
switch(config)#
router eigrp 209
switch(config-router)#
interface ethernet 2/1
switch(config-if)#
no switchport
switch(config-if)#
ip offset-list eigrp 209 route-map OffsetFilter in 20
switch(config-if)#
instance-tag
Name of the EIGRP instance. The
instance-tag
can be any
case-sensitive, alphanumeric string up to 20 characters.
prefix-list
list-name
Specifies the name of an IP prefix list to filter EIGRP routes.
route-map
map-name
Specifies the name of a route map to filter EIGRP routes.
in
Applies the route policy to incoming routes.
out
Applies the route policy to outgoing routes.
offset
Value to add to the EIGRP metric. The range is from 0 to
2147483647.
Release
Modification
5.0(3)A1(1)
This command was introduced.
