140
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
hsrp delay
hsrp delay
To delay Hot Standby Router Protocol (HSRP) initialization after a reload or after an interface comes
up, use the
hsrp delay
command. To disable this function, use the
no
form of this command.
hsrp delay
{
minimum
min-delay
|
reload
reload-delay
}
no delay
{
minimum
min-delay
|
reload
reload-delay
}
Syntax Description
Command Default
The HSRP delay default is 0 seconds.
Command Modes
Interface configuration mode
Command History
Usage Guidelines
The HSRP delayed initialization configuration allows the interface and router to stabilize after the
interface comes up and helps prevent HSRP state flapping.
This command does not require a license.
Examples
This example shows how to configure a minimum delay of 3 seconds and a group initialization delay of
10 seconds:
switch#
configure terminal
switch(config)#
interface ethernet 1/5
switch(config-if)#
no switchport
switch(config-if)#
ip address 192.168.0.5 255.255.255.0
switch(config-if)#
hsrp 1
switch(config-if)#
hsrp delay minimum 3 reload 10
switch(config-if)#
Related Commands
minimum
min-delay
Minimum time (in seconds) to delay HSRP group initialization after an
interface comes up. This period applies to all subsequent interface events.
The range is from 1 to 10,000. The default is 0 seconds.
reload
reload-delay
Time period to delay HSRP group initialization after the router has
reloaded. This period applies only to the first interface-up event after the
router has reloaded. The range is from 1 to 10,000. The default is 0 seconds.
Release
Modification
5.0(3)A1(1)
This command was introduced.
Command
Description
feature hsrp
Enables the HSRP configuration.
