6.6.13. Miscellaneous settings
IMPORTANT
Support for FIPS, CANBUS, PROFINET and QNET are only
available if the corresponding plug-ins are installed. If the
corresponding plug-in is not installed, the check-box for the
relevant option will not be available.
The following plug-ins are needed to activate these features:
• FIPS:
FM-FIPS
• CANBUS:
FM-CANBUS
• PROFINET:
FM-PROFINET
• QNET:
FM-QNET
Note that FIPS support is not available for the FM1000
Gateway and FM10000 Gateway.
Contact your Cisco Networks representative for details.
The
MISC SETTINGS
window contains controls to change the following
settings:
• The device name, as used to identify the Cisco FM3200 Base within
the FMQuadro network map and to other Cisco utilities.
• The operation of the physical Reset button on the unit.
• Device firmware upgrades by trivial file transfer protocol (TFTP).
• The unit's federal information processing standards (FIPS) 140-2
compliance settings (if applicable).
• The unit's controller area network (CANBUS) support settings (if
applicable).
• The unit's process field net (PROFINET) support settings (if
applicable).
• The unit's Neutrino Qnet (QNET) support settings (if applicable).
To change any of the miscellaneous settings, do the following steps:
1.
Click the
-misc settings
link under
ADVANCED SETTINGS
in
the left-hand settings menu.
• The
MISC SETTINGS
dialog will be shown (
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 122 of 176
