Configuring Transport Stream Information
OL-31980-01
185
Mode Status
Description
Unmodified
No changes were made after setting a new Output Mode.
Edited by User
DPM changes were made.
Auto Re-Mapped
The output map changed automatically to fix the output channel
or PID conflicts at the time of setup.
Changed by Uplink DPM output changes were initiated by an encoder.
6
From the
Descrambled
drop-down list, choose whether the output will be
descrambled if the input is scrambled. The following table describes the available
options:
Descramble
Description
Scrambled
The output channel will remain scrambled even if the PE is
authorized and can descramble the channel.
Descrambled
Descrambles the output channel, and passes in-the-clear channels.
7
Choose
Yes
to insert null packets into the output to maintain output at a constant
bit rate from the
Null Packet Insertion
drop-down list. Otherwise, choose
No
.
Note:
We recommend that you set the
Null Packet Insertion
to
Yes
, especially if
the
Output Mode
is set to
Transcoding
.
8
Click
Apply
.
Setting Up the ASI Auto Synchronization Options
The
ASI Auto Sync
area allows you to configure the DPM without editing each
output channel and PID separately.
1
In the ASI Outputs page (
Transport Stream
>
ASI Output
), refer to the
ASI
Auto Sync
area.
2
From the
Enable Auto Fix for Collision
drop-down list, choose
Yes
for the DPM
to resolve channel and PID collisions automatically on the transport outputs.
New values are assigned to the parameters that caused the conflict. The new
assigned values are not used by any incoming transport or other PE outputs. If a
collision is detected, you can review the new changes and click
Apply
to accept
the new changes.
Choose
No
and a detailed list of all the conflicts is displayed in the
Output
Channel and PID Conflicts
table (click
View Conflicts
) when a conflict occurs.
You can then resolve the conflicts manually.
