Chapter 1 Unpacking and Installing the CSS
Installing the CSS 11503
1-16
Cisco 11500 Series Content Services Switch Hardware Installation Guide
78-13884-06
Figure 1-3
Mid-Mounting the Mounting Brackets on the CSS 11503
3.
Secure the mounting bracket to the CSS with four screws provided.
4.
Repeat steps 2 and 3 to install a mounting bracket on the other side of the
CSS.
You are ready to install the CSS in the rack. Before you install the CSS 11503 into
an equipment rack, note the following:
•
Always install heavier equipment in the lower half of a rack to maintain a low
center of gravity. This practice helps prevent the rack from falling over.
•
Install rack stabilizers (if available) before you mount the chassis.
Warning
At least three people are required to mount the chassis in the equipment rack:
two people are needed to hold the chassis in place while a third person
tightens the mounting screws.
To install the CSS 11503 into an equipment rack:
1.
Raise the CSS to the installation height and align the screw holes on the
mounting bracket with the holes on the equipment rack.
2.
Secure each mounting bracket to each side of the rack.
CISCO 11500
SERIES
C O NTENT
S E R VICES S
W I T CH
1
2
3
59539
CSS5-SCM-2GE
System Contr
ol
DUPLEX
LINK/ACT
MANAGEMENT
10BASE-T
SLOT 0
SLOT 1
GE 1
GE 2
LINK
LINK
STATUS
PCMCIA
CONSOLE
1
2
4
5
15
14
13
12
11
10
9
8
7
6
3
CSS5-10M-16FE
DPLX
16 F
ast Ethernet
DPLX
LINK
LINK
1
2
4
5
15
14
13
12
11
10
9
8
7
6
3
CSS5-10M-16FE
DPLX
16 F
ast Ethernet
DPLX
LINK
LINK