3-27
Catalyst 3560 Switch Hardware Installation Guide
78-16057-01
Chapter 3 Switch Installation
Installing and Removing SFP Modules
Caution
Do not remove the dust plugs from the fiber-optic SFP module port or the rubber
caps from the fiber-optic cable until you are ready to connect the cable. The plugs
and caps protect the SFP module ports and cables from contamination and
ambient light.
Step 6
Insert the cable connector into the SFP module:
•
For fiber-optic SFP modules, insert the LC or MT-RJ cable connector into the
SFP module.
•
For copper SFP modules, insert the RJ-45 cable connector into the SFP
module.
Note
When connecting to 1000BASE-T SFP modules, be sure to use a twisted
four-pair, Category 5 cable.
Removing SFP Modules from SFP Module Slots
To remove an SFP module from a module receptacle, follow these steps:
Step 1
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on
the chassis.
Step 2
Disconnect the cable from the SFP module, and insert a dust plug into the cable
end.
Tip
For reattachment, note which cable connector plug is send (TX) and which is
receive (RX).
Step 3
For fiber-optic SFP modules, insert a dust plug into the optical ports of the SFP
module to keep the optical interfaces clean.
Step 4
Unlock and remove the SFP module, as shown in
Summary of Contents for Catalyst 3560
