Chapter 1 Using Express Setup
Configuring the Switch Settings
1-8
Catalyst 3560 Switch Hardware Installation Guide
78-16057-01
•
Did you enter the wrong address in the browser, or is there an error message
displayed in the browser window?
Re-enter
10.0.0.1
in the browser, and press
Enter
.
•
Did you connect a crossover instead of a straight-through Ethernet cable
between an Ethernet port of the switch and the Ethernet port of the PC or
workstation, as shown
Note
See
for instructions on identifying a crossover
cable.
Note
Many legacy powered devices, including older Cisco IP phones and
access points that do not fully support IEEE 802.3AF, might not support
Power over Ethernet (PoE) when connected to the switches by a crossover
cable.
If not, reconnect the cable to the Ethernet port on the switch and PC or
workstation. Wait 30 seconds before entering
10.0.0.1
in the browser.
•
Did you verify that POST successfully ran before starting Express Setup?
If not, make sure that only the SYST and STAT LEDs are green before
pressing the Mode button to begin Express Setup.
Note
The rest of this chapter explains how to configure a switch by using the Express
Setup web page. To configure the switch by using the command-line interface
(CLI)-based setup program, see
Appendix C, “Configuring the Switch with the
Configuring the Switch Settings
The Management Interface field displays
VLAN1-Default
. This is the
management interface through which you manage the switch and to which you
assign IP information.
Summary of Contents for Catalyst 3560
