38-99
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 38 Configuring IP Unicast Routing
Configuring Protocol-Independent Features
To delete an entry, use the
no route-map
map tag
global configuration command or the
no
match
or
no
set
route-map configuration commands.
You can distribute routes from one routing domain into another and control route distribution.
Beginning in privileged EXEC mode, follow these steps to control route redistribution. Note that the
keywords are the same as defined in the previous procedure.
Step 18
set metric
bandwidth delay reliability loading mtu
Set the metric value to give the redistributed routes (only
for EIGRP):
•
bandwidth
—Metric value or IGRP bandwidth of the
route in Kb/s in the range 0 to 4294967295
•
delay
—Route delay in tens of microseconds in the
range 0 to 4294967295.
•
reliability
—Likelihood of successful packet
transmission expressed as a number between 0 and
255, where 255 means 100 percent reliability, and 0
means no reliability.
•
loading
— Effective bandwidth of the route expressed
as a number from 0 to 255 (255 is 100 percent
loading).
•
mtu
—Minimum maximum transmission unit (MTU)
size of the route in bytes in the range 0 to
4294967295.
Step 19
set metric-type
{
type-1
|
type-2
}
Set the OSPF external metric type for redistributed routes.
Step 20
set metric-type internal
Set the multi-exit discriminator (MED) value on prefixes
advertised to an external BGP neighbor to match the IGP
metric of the next hop.
Step 21
set weight
Set the BGP weight for the routing table. The value is
from 1 to 65535.
Step 22
end
Return to privileged EXEC mode.
Step 23
show route-map
Display all configured route maps or only the one
specified to verify configuration.
Step 24
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Command
Purpose
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
router
{
bgp
|
rip
|
ospf
|
eigrp
}
Enter router configuration mode.
A switch running the IP base feature set supports only
the
rip
keyword.
Step 3
redistribute
protocol
[
process-id
] {
level-1
|
level-1-2
|
level-2
} [
metric
metric-value
] [
metric-type
type-value
]
[
match internal
|
external
t
ype-value
] [
tag
tag-value
]
[
route-map
map-tag
] [
weight
weight
] [
subnets
]
Redistribute routes from one routing protocol to
another routing protocol. If no route maps are
specified, all routes are redistributed. If the keyword
route-map
is specified with no
map-tag
, no routes are
distributed.
