3-16
Cisco Wireless LAN Controller Configuration Guide
OL-8335-02
Chapter 3 Configuring Ports and Interfaces
Configuring Dynamic Interfaces
Step 5
Configure the following parameters:
•
VLAN identifier
•
Fixed IP address, IP netmask, and default gateway
•
Physical port assignment
•
Primary and secondary DHCP servers
•
Access control list (ACL) name, if required
Note
To create ACLs, follow the instructions in
Chapter 5
.
Note
To ensure proper operation, you must set the Port Number and Primary DHCP Server
parameters.
Step 6
Click
Save Configuration
to save your changes.
Step 7
Repeat this procedure for each dynamic interface that you want to create or edit.
Using the CLI to Configure Dynamic Interfaces
Follow these steps to configure dynamic interfaces using the CLI.
Step 1
Enter
show interface summary
to view the current dynamic interfaces.
Step 2
To view the details of a specific dynamic interface, enter
show interface detailed
operator-defined-interface-name
.
Step 3
Enter
config wlan disable
wlan-number
to disable each WLAN that uses the dynamic interface for
distribution system communication.
Step 4
Enter these commands to configure dynamic interfaces:
•
config interface create
operator-defined-interface-name
{
vlan-id
|
x
}
Note
Enter a non-zero value for the VLAN identifier. Tagged VLANs must be used for dynamic
interfaces.
•
config interface address
operator-defined-interface-name
ip-addr ip-netmask
[
gateway
]
•
config interface vlan
operator-defined-interface-name
{
vlan-id
|
0
}
•
config interface port
operator-defined-interface-name
physical-ds-port-number
•
config interface dhcp
operator-defined-interface-name
ip-address-of-primary-dhcp-server
[
ip-address-of-secondary-dhcp-server
]
•
config interface acl
operator-defined-interface-name
access-control-list-name
Note
To create ACLs, follow the instructions in
Chapter 5
.
