9-8
Cisco Wireless LAN Controller Configuration Guide
OL-8335-02
Chapter 9 Configuring Radio Resource Management
Viewing RF Group Status
Using the CLI to Configure RF Groups
Follow these steps to configure an RF group using the CLI.
Step 1
Enter
config network rf-network-name
name
to create an RF group.
Note
Enter up to 19 ASCII characters for the group name.
Step 2
Enter
show network
to view the RF group.
Step 3
Repeat this procedure for each controller that you want to include in the RF group.
Viewing RF Group Status
This section provides instructions for viewing the status of the RF group through either the GUI or the
CLI.
Note
You can also view the status of RF groups using the Cisco Wireless Control System (WCS). Refer to the
Cisco Wireless Control System Configuration Guide
for instructions.
Using the GUI to View RF Group Status
Follow these steps to view the status of the RF group using the GUI.
Step 1
Click
Wireless
to access the All APs page (see
Figure 9-2
).
Figure 9-2
All APs Page
