2-7
Cisco Video Surveillance 6020 IP Camera Installation Guide
OL-28120-02
Chapter 2 Camera Installation
IP Camera Installation
Mounting the IP Camera Flush with a Surface
To mount the 6020 IP camera flush with a surface, complete the following steps:
Procedure
Step 1
Secure the IP camera inside the camera housing using the two included screws.
Step 2
Remove the ceiling tile from the location at which you want to mount the IP dome and cut a 7-3/4 inch
(19.68 cm) diameter hole in the center of the tile.
Step 3
Place the camera housing through the hole that you cut in the ceiling tile.
Step 4
(Optional) Place a ceiling tile mount over the camera housing.
Orient the ceiling tile mount so that it is flush with the back surface of the ceiling tile.
Step 5
Use a Phillips-head screwdriver to turn the anchor screws clockwise and spin the anchor clips outward
into the locking position and to secure the anchor clips.
The anchor clips twist over the ceiling tile. Turn the anchor clip screws until the camera housing is snug
against the ceiling tile. Do not over tighten the screws.
