2-11
Cisco Video Surveillance 6020 IP Camera Installation Guide
OL-28120-02
Chapter 2 Camera Installation
IP Camera Installation
Step 5
Secure the IP camera to the conduit base with two included screws.
Step 6
Feed a shielded twisted pair (STP) Category 5 or higher network cable through the conduit base and
connect to the LAN port on the back of the camera. Connect the other end of the network cable to a
10/100/BaseT router or switch.
If your network provides PoE, the IP camera powers on.
Step 7
(Optional) Feed the following cables through the conduit base and connect to the GPIO terminal block
on the IP camera:
•
External power cable to the GPIO terminal block if PoE is not available.
•
(Optional) I/O cables for external input or out put devices, such as sensors or alarms, to the GPIO
terminal block
The pin locations and descriptions are as follows:
Step 8
(Optional) Use a mini cable with BNC connector to temporarily attach an NTSC or PAL compliant
analog video display device to the analog video out port on the IP camera.
Pin
Description
1
12 VDC-
2
12 VDC+
3
24 VAC
4
24 VAC
5
DI-
6
DI+
7
DO-
8
DO+
8
7
6
5
4
3
2
1
