B-14
Catalyst 3750 Switch Command Reference
OL-8552-07
Appendix B Catalyst 3750 Switch Debug Commands
debug ilpower
debug ilpower
Use the
debug ilpower
privileged
EXEC command to enable debugging of the power controller and
Power over Ethernet (PoE) system. Use the
no
form of this command to disable debugging.
debug ilpower
{
cdp
|
controller | event | ha | port
|
powerman
|
registries
}
no debug ilpower
{
cdp
|
controller | event | ha | port
|
powerman
|
registries
}
Syntax Description
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
This command is supported only on PoE-capable switches.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the
session
switch-number
privileged
EXEC command. Then enter the
debug
command at the command-line prompt of the stack member. You
also can use the
remote command
stack-member-number
LINE
privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
cdp
Display PoE Cisco Discovery Protocol (CDP) debug messages.
controller
Display PoE controller debug messages.
event
Display PoE event debug messages.
ha
Display PoE high-availability messages.
port
Display PoE port manager debug messages.
powerman
Display PoE power management debug messages.
registries
Display PoE registries debug messages.
Release
Modification
12.1(19)EA1
This command was introduced.
12.2(25)SE
The
cdp
,
ha
, and
powerman
keywords were added.
Command
Description
Displays the values in the registers of the specified PoE controller.
Displays the power status for the specified PoE port or for all PoE
ports.
