2-428
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
police aggregate
police aggregate
Use the
police aggregate
policy-map class configuration command to apply an aggregate policer to
multiple classes in the same policy map. A policer defines a maximum permissible rate of transmission,
a maximum burst size for transmissions, and an action to take if either maximum is exceeded. Use the
no
form of this command to remove the specified policer.
police aggregate
aggregate-policer-name
no police aggregate
aggregate-policer-name
Syntax Description
Defaults
No aggregate policers are defined.
Command Modes
Policy-map class configuration
Command History
Usage Guidelines
The port ASIC device, which controls more than one physical port, supports 256 policers (255
user-configurable policers plus 1 policer reserved for internal use). The maximum number of
user-configurable policers supported per port is 63. Policers are allocated on demand by the software
and are constrained by the hardware and ASIC boundaries. You cannot reserve policers per port. There
is no guarantee that a port will be assigned to any policer.
You set aggregate policer parameters by using the
mls qos aggregate-policer
global configuration
command. You apply an aggregate policer to multiple classes in the same policy map; you cannot use
an aggregate policer across different policy maps.
To return to policy-map configuration mode, use the
exit
command. To return to privileged EXEC mode,
use the
end
command.
Policy maps that use the
police aggregate
command fail when applied to a 10-Gigabit Ethernet
interface.
You cannot configure aggregate policers in hierarchical policy maps.
aggregate-policer-name
Name of the aggregate policer.
Release
Modification
12.1(11)AX
This command was introduced.
