Chapter 2 Switch Installation
Connecting to the 10/100/1000 Ports
2-28
Catalyst 2970 Switch Hardware Installation Guide
OL-6422-01
To maximize performance, choose one of these methods for configuring the
Ethernet ports:
•
Let the ports autonegotiate both speed and duplex.
•
Set the port speed and duplex parameters on both ends of the connection.
Follow these steps to connect to 10BASE-T, 100BASE-TX or 1000BASE-T
devices:
Caution
To prevent electrostatic-discharge (ESD) damage, follow your normal board and
component handling procedures.
Step 1
When connecting to workstations, servers, routers, and Cisco IP Phones, connect
a straight-through cable to an RJ-45 connector on the front panel. (See
Figure 2-23
.) When connecting to switches or repeaters, use a crossover cable.
(See the
“Cable and Adapter Specifications” section on page B-5
for cable-pinout
descriptions.)
Note
When connecting to 1000BASE-T-compatible devices, be sure to use a twisted
four-pair, Category 5 cable.
Note
You can use the
mdix auto
interface configuration command in the CLI to enable
the automatic medium-dependent interface crossover (Auto-MDIX) feature.
When the Auto-MDIX feature is enabled, the switch detects the required cable
type for copper Ethernet connections and configures the interfaces accordingly.
Therefore, you can use either a crossover or a straight-through cable for
connections to a copper 10/100/1000 or 1000BASE-T SFP module port on the
switch, regardless of the type of device on the other end of the connection.
The Auto-MDIX feature is enabled by default on switches running Cisco IOS
Release 12.2(18)SE or later. For releases between Cisco IOS
Release 12.1(14)EA1 and 12.2(18)SE, the Auto-MDIX feature is disabled by
default. For configuration information for this feature, see the switch software
configuration guide or the switch command reference
.
Summary of Contents for 2970 - Catalyst Switch
Page 4: ......
