Appendix C Configuring the Switch with the CLI-Based Setup Program
Entering the Initial Configuration Information
C-10
Catalyst 2970 Switch Hardware Installation Guide
OL-6422-01
Step 6
(Optional) Configure Simple Network Management Protocol (SNMP) by
responding to the prompts. You can also configure SNMP later through the CLI,
the device manager, or the Network Assistant application. To configure SNMP
later, enter
no
.
Configure SNMP Network Management? [no]:
no
Step 7
Enter the interface name (physical interface or VLAN name) of the interface that
connects to the management network, and press
Return
. For this release, always
use vlan1 as that interface.
Enter interface name used to connect to the
management network from the above interface summary:
vlan1
Step 8
Configure the interface by entering the switch IP address and subnet mask and
pressing
Return
. The IP address and subnet masks shown below are examples.
Configuring interface vlan1:
Configure IP on this interface? [yes]:
yes
IP address for this interface:
10.4.120.106
Subnet mask for this interface [255.0.0.0]:
255.0.0.0
Step 9
Enter
Y
to configure the switch as the cluster command switch. Enter
N
to
configure it as a member switch or as a standalone switch.
If you enter
N
, the switch appears as a candidate switch in the Network Assistant
GUI. You can configure the switch as a command switch later through the CLI,
the device manager, or the Network Assistant application. To configure it later,
enter
no
.
Would you like to enable as a cluster command switch? [yes/no]:
no
You have now completed the initial configuration of the switch, and the switch
displays its initial configuration. This is an example of output that appears:
The following configuration command script was created:
hostname switch1
enable secret 5 $1$Ulq8$DlA/OiaEbl90WcBPd9cOn1
enable password
enable_password
line vty 0 15
password
terminal-password
no snmp-server
!
no ip routing
!
interface Vlan1
no shutdown
Summary of Contents for 2970 - Catalyst Switch
Page 4: ......
