C-11
Catalyst 2970 Switch Hardware Installation Guide
OL-6422-01
Appendix C Configuring the Switch with the CLI-Based Setup Program
Entering the Initial Configuration Information
ip address 10.4.120.106 255.0.0.0
!
interface FastEthernet1/0/1
!
interface FastEthernet1/0/2
interface FastEthernet1/0/3
!
...<output abbreviated>
!
interface GigabitEthernet2/0/28
!
end
Step 10
These choices are displayed:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots,
save it in NVRAM by selecting option 2.
Enter your selection [2]:
2
Make your selection, and press
Return
.
After you complete the setup program, the switch can run the default
configuration that you created. If you want to change this configuration or want
to perform other management tasks, use one of these tools:
•
Command-line interface (CLI)
•
Network Assistant (for one or more switches)
To use the CLI, enter commands at the
Switch
> prompt through the console port
by using a terminal program or through the network by using Telnet. For
configuration information, see the switch software configuration guide or the
switch command reference.
To use the Network Assistant, see the
Getting Started with Cisco Network
Assistant
guide on Cisco.com.
Summary of Contents for 2970 - Catalyst Switch
Page 4: ......
