3-45
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
OL-11496-01
Chapter 3 Installing the Router
Connecting GRP Route Processor Cables
RJ-45 Connection
Refer to
and use the following procedure to connect an Ethernet cable
to the RJ-45 receptacle on the GRP:
Step 1
Plug the cable directly into the RJ-45 receptacle.
Step 2
Connect the network end of your RJ-45 cable to your transceiver, switch, hub,
repeater, DTE, or other external equipment.
Note
The Ethernet interfaces on the GRP are endstation devices only, not
repeaters.
MII Connection
The MII receptacle requires an external transceiver that permits connection to
multimode fiber for 100BASE-FX or 100BASE-T4 physical media. Depending on
the type of media you use between the MII receptacle and your switch or hub, the
network side of your 100-Mbps transceiver should be appropriately equipped with
ST-type connectors (for fiber-optic cables), BNC connectors, and so forth.
Refer to
and use the following procedure to connect a cable to the MII
Ethernet receptacle on the GRP.
Step 1
Connect the cable directly to the MII receptacle, or attach a 100BASE-T
transceiver (with the media appropriate to your application) to the MII receptacle.
Step 2
Connect the network end of your MII cable to your transceiver, switch, hub,
repeater, DTE, or other external equipment.
Note
The Ethernet interfaces on the GRP are endstation devices only, not
repeaters.
Summary of Contents for 12010 series
Page 6: ......
