3-16
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 3 Configuring Remote Access to MPLS VPN
Configuration Tasks for RA to MPLS VPN
address-family vpnv4
neighbor 10.1.1.4 activate
neighbor 10.1.1.4 send-community both
neighbor 10.3.1.4 activate
neighbor 10.3.1.4 send-community both
exit-address-family
!
Note
Typically, you enable BGP only on the PE routers. It is not necessary to enable BGP on all provider (P)
core routers. However, if your network topology includes a route reflector, you may then enable BGP on
a core router, which might be a P or PE router.
Configuring Access Protocols and Connections
The Cisco 10000 series router supports the following access protocols:
•
PPP over ATM
•
PPP over Ethernet
•
RBE over ATM
When a remote user initiates a PPPoA or PPPoE session to the Cisco 10000 series router, a predefined
configuration template is used to configure a virtual interface known as a virtual access interface (VAI).
The VAI is created and configured dynamically by using a virtual template interface. When the user
terminates the session, the VAI goes down and the resources are freed for other client uses.
Note
Virtual template interfaces and VAIs do not apply to RBE over ATM.
The virtual template interface is a logical entity that the Cisco 10000 series router applies dynamically
as needed to a connection. It is a configuration for an interface, but it is not tied to the physical interface.
The VAI uses the attributes of the virtual template to create the session, which results in a VAI that is
uniquely configured for a specific user.
After you configure a virtual template, configure the virtual connection that will use the template and
then apply the template to the connection. The order in which you create virtual templates and configure
the virtual connections that use the templates is not important. However, both the virtual templates and
connections must exist before a remote user initiates a session to the Cisco 10000 series router.
The following sections describe how to create a virtual template and apply it to a VAI. For more
information, see the “Configuring Virtual Template Interfaces” chapter in the
Cisco IOS Dial
Technologies Configuration Guide, Release 12.2
.
Note
If you are using a RADIUS server, the RADIUS configuration takes precedence over the virtual template
interface configuration. For example, the RADIUS configuration might override a number of parameters
with the remainder of the configuration coming from the virtual template interface.
To configure access protocols and connections, perform the following configuration tasks. The first task
listed is required and you can perform any of the remaining tasks as needed:
•
Configuring a Virtual Template Interface, page 3-17
•
Configuring PPP over ATM Virtual Connections and Applying Virtual Templates, page 3-18
•
Configuring PPPoE over ATM Virtual Connections and Applying Virtual Templates, page 3-18
