VCC-16MV02
Rev.905-0163-00
©2018 CIS Corporation. All rights reserved.
29
□
Indication of defective pixels (Address 104)
Operation when setting data and operation when acquiring data are different.
(1)
When setting (SU 104)
This is the function to indicate the actually corrected pixels by that time, with 75% brightness.
On/Off can be executed by parameters.
Parameter 0: OFF
Parameter 1: ON
Bright point indication function cannot be saved.
(2)
When acquiring (GU 104)
This is the function to indicate the registered defective pixels.
Three kinds of lists can be indicated by parameters.
Parameter 1: Entire lists, both ex-factory data, and the added and registered data by the users, are shown.
Parameter 2: Only the list added and registered by the users is shown.
(Example of indication)
From the left, X coordinate, Y coordinate, and the type of defects
[Type of defects]
W: White defects registered at Ex-factory
B: Black defects registered at Ex-factory
U: White defects registered by the user
P: Defects added by the user
Parameter 3:
Indicates the number of the registered defective pixels per CH (Data at Ex-f Data
registered by the user.)
Parameter 4:
Indicates the number of the registered defective pixels per CH (Data registered by the user
only.)
「
Notes for coordinate indication
」
X coordinate and Y coordinate shown are the one for the current image. When vertical partial (SU50,
54), horizontal flip (SU11), or vertical flip (SU12) is changed, the coordinates to be indicated shall be
changed accordingly.
The lists shown by parameters 3 and 4 are only the registered data in the currently shown image area.
(When indication image size was reduced, some registered data by the user could be out of area. In
such case, the coordinate points out of the indication area would not be shown.)
To show the coordinate points out of the area, execute parameter 1 or parameter 2. These points would
be shown as minus coordinate or as the one of the out of image size.
925 443 W
1228 460 W
1271 488 W
500 500 P
1098 520 W
930 629 U
