CIS VCC-16MV02, Product Specification & Operational Manual

Page: 25 / 35

VCC-16MV02 Rev.905-0163-00
©2018 CIS Corporation. All rights reserved.
24
□
Entire frame line count = V blanking line count +
Partial effective lines 1 + Partial effective lines 2 +
・・・
+ Partial effective lines 8
Note that sum total of partial effective line count from 1 ~ 8 (except V blanking lines) has to be less than 3000.
V blanking line count at partial mode is 62H.
□
Frame rate = 1 / (Entire frame line count × Time for 1 line)
Time for 1 line
Camera Mode Time for 1 line
2Tap Configuration mode 24.512μs
4Tap Configuration mode 12.256μs
8Tap Configuration mode 6.128μs
10Tap Configuration mode 5.185μs
□ Setting Examples
Effective
Frame rate (Entire frame line count)
Lines
2Tap mode 4Tap mode 8Tap mode 10Tap mode
4(Min.) 4 H fps (H) fps (H) fps (H) fps (H)
・ ・
618.1 66 1236.3 66 2472.5 66 2922.2 66
Vertical:
VGA equivalent
480 H fps (H) fps (H) fps (H) fps (H)
・ ・
75.3 542 150.5 542 301.1 542 355.8 542
Vertical:
XGA equivalent
768 H fps (H) fps (H) fps (H) fps (H)
・
49.2 830 98.3 830 196.6 830 232.4 830
Vertical:
SXGA equivalent
1024 H fps (H) fps (H) fps (H) fps (H)
・ ・
37.6 1086 75.1 1086 150.3 1086 177.6 1086
Vertical:
UXGA equivalent
1200 H fps (H) fps (H) fps (H) fps (H)
・ ・
32.3 1262 64.7 1262 129.3 1262 152.8 1262
3000(Max.
）
3000 H fps (H) fps (H) fps (H) Fps (H)
Full frame 13.3 3062 26.6 3062 53.3 3062 63.0 3062
□
The line numbers at partial scan setting can be set from 4 lines. Only multiple numbers of 4 can be set.
□
As to the manual shutter setting value at partial scan, the effective line number becomes the maximum value.
□
At partial scan setting ON/OFF, the coordinates of a cursor is reset to (0, 0).
□
To change the partial setting (address 50), execute it when partial is set to OFF.
□
When you switch modes between Full Frame Scan Mode and Partial Scan Mode, or when you change Partial scan
settings, the first one frame right after the changes shall be invalid.
*Especially at fixed trigger shutter mode and pulse width trigger shutter mode, input a dummy trigger
first, and use the next trigger as an actual video signal.