Circutor VLOG-10, Instruction Manual

Page: 15 / 30

15 Instruction Manual
VLOG-10
Table 5 (Cont�): LED status: Analysis of the mains (table 1)
Status SAMPLING EVENT
Device analysing the mains with frequency deviation detected
(lower or upper)
(x1) (x3)
Device analysing the mains with low battery detected
(< 2.2 V)
(x2) (*)
Note: In the SAMPLING and EVENT columns, the number of flashes in each 2-second interval
is shown in brackets:
(x1) One 0.2-second flash in 2-second intervals.
(x2) Two 0.2-second flashes in 2-second intervals.
(*)
Number of flashes as per above cases
B�- The device is not analysing or storing any logs in the memory due to a serious issue.
Table 6: LED status: Analysis of the mains (table 2)
Status SAMPLING EVENT
Device has no preconfigured time
(x1)
Battery drained (<1.7 V)
(x2)
RAM full (if memory configured to “non-circular”)
(x3)
Error starting RAM hardware
(x4)
Error starting FLASH hardware
(x5)
Note: In the EVENT column, the number of flashes in each 2-second interval is shown in
brackets:
(x1) One 0.2-second flash in 2-second intervals.
(x2) Two 0.2-second flashes in 2-second intervals.
���
4�4�2�- UPLOADING DATA TO THE PC
When the VLOG-10 device is connected via the USB connector, the LEDs represent the
following statuses,
Table 7
:
Table 7: LED status: Uploading data to the PC�
Status SAMPLING EVENT
USB interface started
Management software detectedLink established
(x1)
Data transmission / reception
(x1) (*)
Note:
In the
SAMPLING
and
EVENT
columns, the number of flashes in each 2-second interval
is shown in brackets:
(x1) One 0.2-second flash in 2-second intervals.
(*)
Flashes according to the data transfer rate.