30
13. Appendix
USB configuration for remote programming
This application note describes the procedure to configure the USB port for remote
programming application.
The remote programmable power supply with USB can be connected to PC
through USB cable.
USB to serial bridge design is used. When connected to PC, it will be converted
as COM port shown in the following picture. e.g. COM3
If the COM port does not come up, please check if the USB driver has been prob-
ably installed. The USB driver comes with software CD. Make sure the CD has been
loaded to computer first. Then it can program as standard COM port.
The power supply then can be programmed for remote control etc. by the ASCII
commands via the COM3. All the command sets are given in the user manual of
the power supply.
The default COM port setting;
baud rate : 9600
Data bits : 8 bit
stop bit : 1
Parity : None
Summary of Contents for PSC-6916
Page 2: ...2 PSC 6916 6932 6960 08R14...
Page 31: ...31 Notes...
