Document: Service Manual
Description: Treadmill
Model: M7 E / M7L E
Page: 8 of 25
8
1.2.
【
E1
】
:When memory device damaged or read or write had program, all window display
will be off and all output will be stop and shows
【
E1
】
on TIME window, shows
【
EEPROM
ERROR
】
on dot-matrix window.
1.2.1.
Solution: Replace the console PCB.
1.3.
【
E2
】
:IF incline had some problems when initial, incline can not reach the right position,
will shows
『
ELEVATION ERROR PRESS STOP TO BYPASS
』
on dot-matrix window, press
STOP to bypass the signal but incline function can not be use, if incline had some
problems when during workout, the INCLINE window will shows
【
E2
】
but other function
are normal to use.
※
If this is a all new product that just finished assemble, there are more possibly in
assemble problems, maybe connect wire not well or wire damaged while assemble.
1.3.1.
Steps illustrate:
Step
illustrate
Auxiliary Photo
1
Open the motor cover then switch OFF the
AC power source and wait 10 seconds then
ON the AC power.
2
Check the pilot lamps LED4 & LED5 on
interface PCB before shows
【
E2
】
.
The LED4 or LED5 light up before show E2?
Yes: Next step.
No: Check console wire is connected well.
Refer to:
2.1
『
Interface PCB
』
2.2
『
Console Wire
』
OFF
ON
Summary of Contents for M-7 SERIES E TYPE
Page 1: ......
