EES3 Hardware Interface Description
8.2 Compliance with FCC and IC Rules and Regulations
116
EES3_HD_v01.100b
Page 115 of 118
2009-08-12
Confidential / Released
8.2
Compliance with FCC and IC Rules and Regulations
The Equipment Authorization Certification for the Cinterion Wireless Modules reference appli-
cation described in
will be registered under the following identifiers:
FCC Identifier: QIPEES3
Industry Canada Certification Number: 7830A-EES3
Granted to Cinterion Wireless Modules GmbH
Manufacturers of mobile or fixed devices incorporating EES3 modules are authorized to use
the FCC Grants and Industry Canada Certificates of the EES3 modules for their own final prod-
ucts according to the conditions referenced in these documents. In this case, an FCC/ IC label
of the module shall be visible from the outside, or the host device shall bear a second label stat-
ing "Contains FCC ID QIPEES3", and accordingly “Contains IC 7830A-EES3“.
IMPORTANT:
Manufacturers of portable applications incorporating EES3 modules are required to have their
final product certified and apply for their own FCC Grant and Industry Canada Certificate relat-
ed to the specific portable mobile. This is mandatory to meet the SAR requirements for portable
mobiles (see
for detail).
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
The EES3 reference application registered under the above identifiers is certified to be in ac-
cordance with the following Rules and Regulations of the Federal Communications Commis-
sion (FCC) and Industry Canada Certificate (IC):
FCC Section 15.105 (b)
"This equipment has been tested and found to comply with the limits for a Class B digital de-
vice, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help."
FCC Section 15.19 Labelling requirements
"This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation."
