TRANSTIG 220AC/DC AND 300AC/DC POWER SOURCE
Manual 0-5293
3-33
INSTALLATION, OPERATION AND SETUP
EEProm checksum error Communication with
EEProm is faulty
Switch machine off,
then back on. Perform
a master reset. If the
problem continues have
an Accredited CIGWELD
Service Provider check
the power source.
EEProm read / write error Communication with
EEProm is faulty
Switch machine off,
then back on. Perform
a master reset. If the
problem continues have
an Accredited CIGWELD
Service Provider check
the power source.
Table 3-11: Information Messages
3.20 Error Messages
If a message has been displayed, have an Accredited CIGWELD Service Provider check the power source.
Message Code
Error
Cause
Possible Remedy
Thermal Overload of
Output Diodes
Duty Cycle has been
exceeded
Leave the power source
switched ON and allow it
to cool.
Thermal Overload of
Primary Module
Duty Cycle has been
exceeded
Leave the power source
switched ON and allow it
to cool.
Thermal Overload of
Transformer
Duty Cycle has been
exceeded
Leave the power source
switched ON and allow it
to cool.
Thermal Overload of
PFC Module
Duty Cycle has been
exceeded
Leave the power source
switched ON and allow it
to cool.
Mains Supply Over
Voltage
Mains Supply Voltage
is too high
Check Mains Supply
Voltage
Water Pump (in water
cooled operation)
Torch Monitor (in gas
cooled operation)
Defective connection
cable or water cooler
Water cooled GTAW
torch connected
Check the Net Connection
water cooler cable and the
water cooler.
Use a gas cooled torch
S e c o n d a r y O v e r
Voltage
Initial Voltage is too
high
Have an Accredited
C I G W E L D S e r v i c e
Provider check the power
source
Voltage Detection
Voltage Detection Error Have an Accredited
C I G W E L D S e r v i c e
Provider check the power
source
Voltage Detection plug
socket
Voltage Detection Error
in module 2
Have an Accredited
C I G W E L D S e r v i c e
Provider check the power
source
Torch / Remote Control R e m o t e C o n t r o l ,
Torch or connections
defective
Check or replace Torch or
Remote Control
Summary of Contents for A-12030
Page 6: ......