TRANSTIG 220AC/DC AND 300AC/DC POWER SOURCE
Manual 0-5293
3-5
INSTALLATION, OPERATION AND SETUP
3. Worklead Welding Terminal
Worklead Welding Terminal. Welding current flows from the Power Source via heavy duty bayonet type
terminals. It is essential, however, that the male plug is inserted and turned securely to achieve a sound
electrical connection
CAUTION
Loose welding terminal connections can cause overheating and result in the male plug being fused in the
terminal.
4. Shielding Gas Outlet
The Shielding Gas Outlet located on the front panel is a 5/8-18 UNF female gas fitting and is utilised for
the connection of a suitable TIG Torch.
5. Main On/Off Switch
This Switch is located on the rear of the Power Source and turns mains power off and on.
!
WARNING
When the front digital displays are lit, the machine is connected to the Mains supply voltage and
the internal electrical components are at Mains voltage potential.
6. Mains Supply Lead
The Transtig 220AC/DC is fitted with a heavy duty 15 Amp mains supply lead and plug.
The Transtig 300AC/DC is fitted with a heavy duty three phase mains supply lead.
7. Gas Inlet
The Shielding Gas Inlet connection is used to supply the appropriate shielding gas to the unit. The gas
inlet is located on the rear of the Power Source.
!
WARNING
Only Inert Shielding Gases specifically designed for welding applications should be used.
8. Water Cooler Interface
The Water Cooler Interface is used to control a water cooler that may be attached to the unit. The Water
Cooler Interface is located on the rear of the Power Source.
NOTE
Water Cooler is available for 300AC/DC only.
9. Remote Control Socket (Automation)
The 14 pin Automation Remote Control Socket is used to connect remote control devices to the welding
power source.
To make connections, align keyway, insert plug, and rotate threaded collar fully clockwise.
The Automation Remote Control Socket is located on the rear of the Power Source.
Summary of Contents for A-12030
Page 6: ......
