7
– 23
7.
3.16 TH1 “Primary Thermistor”
UV\
1 ) Remove the Side Panel. [See section “
6
.1-1”]
2 ) Remove the snap band. Disconnect the connector CN5 on the PCB1. Remove the screw and then
detach the TH1. Before installing a new Thermistor, apply a uniform coat of silicone compound (Shinetsu
Silicone G-747 or equivalent) on the base.
7.
3.17 TH2 “Secondary Thermistor”
UV\
1 ) Remove the Side Panel. [See section “
6
.1-1”]
2 ) Remove PCB3 unit. [See section “
7
.3-3”]
3 ) Cut the three snap bands. Disconnect the connector CN6 on the PCB1. Remove the screw and then
detach the TH1. Before installing a new Thermistor, apply a uniform coat of silicone compound (Shinetsu
Silicone G-747 or equivalent) on the base.
CN5
3
1
2
3
1
1
2
4
CN6
SERVICE MANUAL
MAINTENANCE
TRANSTIG 200 Pi