53
Programmation
52
TDC26-TDC36-TM26GSM-TM66GSM-ERMES2- User’s manual
NOTE: To the first ignition the combiner demands the choice of the language to
use.The available languages are: Italian, English, French, Spanish,
Portuguese, German.
Select the language with
or
and press
or
3.7.3 Reply
pulse
Indicates the number of rings the combiner waits for before responding to the call
when remote control is enabled.
!
Key in the code:
(Default MASTER code)
!
Press the button:
(Programming)
!
Press the button:
(Parameters)
!
Press the button:
(
Reply pulse
)
!
This will be displayed:
!
Press the button:
or
!
This will be displayed:
Select the number of pulses, from 0 to 40 seconds.
NOTE: The combiner don’t accept a number greater than 40 is keyed in. If the
setting '00' is made, the combiner does not respond to external calls.
!
Press the button
or
3.7.4 Number
of
calls
This parameter sets how many call attempts the combiner carries out for each
number in the directory in one alarm cycle.
!
Key in the code:
(Default MASTER code)
!
Press the button:
(Programming)
!
Press the button:
(Parameters)
!
Press the button:
(
Number of calls
)
!
This will be displayed:
!
Press the button:
oppure
!
This will be displayed:
R e p l y
I n p u l s e s
0 2
_
R e p l y
I n p u l s e s
- -
_
N o .
O f
C a l l s
3
_
_
N o .
O f
C a l l s
-
_
_
Select the number of calls (9 maximum).
Use the
or
NOTE: If a “STOP CURRENT CALL” command is sent from the connected telephone
during connection (see para 4.2.7), the call is no longer repeated during the
cycle. With the “STOP CURRENT CYCLE” or “STOP ALL CYCLES”
command, no further calls will be carried out for the current cycle or for all
active cycles.
3.7.5
Number
of
messages
This parameter indicates how many times the voice messages (common
m channel message) are repeated at each call.
!
Key in the code:
(Codice default MASTER)
!
Press the button:
(Programmazione)
!
Press the button:
(Parametri)
!
Press the button:
(
Num. Messaggi
)
!
This will be displayed:
!
Press the button:
or
!
This will be displayed:
Key in the number of voice messages (9 maximum).
!
Use the
or
NOTE: The call will be interrupted a few seconds following the end of the
messages if the remote control does not intervene.
3.7.6
Beep
no
registr.
Enabling this parameter, the phone dialer sounds a signal in the absence of GSM
signal
!
Key in the code:
(Default MASTER code)
!
Press the button:
(Programming)
!
Press the button:
(Parameters)
!
Press the button:
(
Beep No registr.
)
!
This will be displayed:
Use the
or
to select which parameter to use. Then press the
or
.
NOTE: By default this parameter is set to OFF.
N o .
O f
M e s s a g e s
3
_
_
N o .
O f
M e s s a g e s
-
_
_
9
9
B e e p N o R e g i s t r .
O n
