Chziri ZVF300H, User Manual

Page: 107 / 219

Chapter 6 Detailed function description
-102-
0
：
Command invalid when powered on .
Although detected effective commandof terminal in process of powered on . the
inverter will not run .the system is running is the protection state until withdrawal of the
terminal operation command .and then enable the terminal.inverter will run .
1
：
Command valid when powered on
That is to say when the inverter is in the process of powered on . If detected the
effective operation the command of terminal . waiting for the complection of initialization.
the system will automatically start the inverter .
The user select this function with caruton .
Otherwise may lead to serious consequences .
F1.12 Input/Output terminal selection
Setting range:0x000
～
0x7FF Factory setting :0x000
This function code defines the positive and negative logic of terminals.
Positive logic 0: Valid when connecting SI with corresponding common
terminal and invalid when dis connecting these terminal .
Negative logic 1: Invalid when connecting SI with corresponding common
terminal and valid when disconnecting these terminals.
If you request X1~X4 is positive logic, X5
～
X8 is negative logic ,Y1,Y2
is positive logic,RY is negative logic . The setting are as follows :
The logic state of X4-X1 is 0000,and the corresponding hex is 0. The unit
digit of LED is displayed to 0. the logic state of X8-X5 is 1111. and the corresponding
hex is F. the logic state of RY ,Y1,Y2 is 100. and the corresponding hex is 4. The
tens digit of LED is The function code of F1.12 is 4F0.As shown in Figure 6-6.