Chziri ZVF300H, User Manual

Page: 135 / 219

Chapter 6 Detailed function description
-130-
F7 Group-Human-machine interface
F7.00 The user password
Setting range: 0
～
65535 Factory setting :0
The password protection function will be valid when set to be any nonzero data .
When F7.00 is set to be 0000, the user’s password set before will be cleared and
the password protection gunction will be disable .
After the password has been set and becomes valid .the user can not access
menu if the user’s password is not correct .Only when a correct the user’s password
is input, the user can see and modify the parameters .Please keep the user’s password
in mind .
The password will be valid in 1 mintue after retreat the function code edition state .
Press MODE to enter into the function code edition state after the password takes effect .
0.0.0.0.” will be displayed .the operator should input correct password .
F7.01 The initial selection when Power on
Setting Range :0x0000
～
0x0C1F Factory Setting :0x0000
The function code determines the displayed content when the inverter is power
on ,The units of LED, decade bits are used to set the running status display selection;
hundreds and thousands of LED are used to set the stop status display selection. The
initial content display can only select a project, data format is hexadecimal.
Specific display content corresponding to parameter value refer to F7.06-F7.08.
For examole: The running state and stop state will dispaly the inital count value and
input AC voltage . the setting is 0x0A10 .the count value is 16th bit .so hexadecimal
is 10. the input ac voltage is the 10 bit .so the hex is 0A.