Chrysler PT Cruiser, Service & Repair Manual, Page: 26 / 2078

HOISTING
STANDARD PROCEDURE - HOISTING
Refer to Owner’s Manual provided with vehicle for
proper emergency jacking procedures.
WARNING: THE HOISTING AND JACK LIFTING
POINTS PROVIDED ARE FOR A COMPLETE VEHI-
CLE. WHEN THE ENGINE OR REAR SUSPENSION
IS REMOVED FROM A VEHICLE, THE CENTER OF
GRAVITY IS ALTERED MAKING SOME HOISTING
CONDITIONS UNSTABLE. PROPERLY SUPPORT OR
SECURE VEHICLE TO HOISTING DEVICE WHEN
THESE CONDITIONS EXIST.
CAUTION: Do not position hoisting device on sus-
pension components, damage to vehicle can result.
Do not attempt to raise one entire side of the vehi-
cle by placing a floor jack midway between the
front and rear wheels. This practice may result in
permanent damage to the body.
When properly positioned, a floor jack can be used
to lift the vehicle and support the raised vehicle with
jack stands (Fig. 5).
A floor jack or any lifting device, must never be
used on any part of the underbody other then the
described areas.
JUMP STARTING
STANDARD PROCEDURE - JUMP STARTING
WARNING: REVIEW ALL SAFETY PRECAUTIONS
AND WARNINGS IN BATTERY/STARTING/CHARG-
ING SECTIONS. DO NOT JUMP START A FROZEN
BATTERY, PERSONAL INJURY CAN RESULT. DO
NOT JUMP START WHEN MAINTENANCE FREE
BATTERY INDICATOR DOT IS YELLOW OR BRIGHT
COLOR. DO NOT JUMP START A VEHICLE WHEN
THE BATTERY FLUID IS BELOW THE TOP OF LEAD
PLATES.
DO NOT ALLOW JUMPER CABLE
CLAMPS TO TOUCH EACH OTHER WHEN CON-
NECTED TO A BOOSTER SOURCE. DO NOT USE
OPEN FLAME NEAR BATTERY. REMOVE METALLIC
JEWELRY WORN ON HANDS OR WRISTS TO AVOID
INJURY BY ACCIDENTAL ARCING OF BATTERY
CURRENT. WHEN USING A HIGH OUTPUT BOOST-
ING DEVICE, DO NOT ALLOW BATTERY VOLTAGE
TO EXCEED 16 VOLTS. REFER TO INSTRUCTIONS
PROVIDED WITH DEVICE BEING USED.
CAUTION: When using another vehicle as a
booster, do not allow vehicles to touch. Electrical
systems can be damaged on either vehicle.
TO JUMP START A DISABLED VEHICLE:
(1) Raise hood on disabled vehicle and visually
inspect engine compartment for:
•
Battery cable clamp condition, clean if necessary.
•
Frozen battery.
•
Yellow or bright color test indicator, if equipped.
•
Low battery fluid level.
•
Generator drive belt condition and tension.
•
Fuel fumes or leakage, correct if necessary.
CAUTION: If the cause of starting problem on dis-
abled vehicle is severe, damage to booster vehicle
charging system can result.
(2) When using another vehicle as a booster
source, park the booster vehicle within cable reach.
Turn off all accessories, set the parking brake, place
the automatic transmission in PARK or the manual
transmission in NEUTRAL and turn the ignition
OFF.
(3) On disabled vehicle, place gear selector in park
or neutral and set park brake. Turn off all accesso-
ries.
(4) Connect jumper cables to booster battery. RED
clamp to positive terminal (+) or remote terminal.
BLACK clamp to negative terminal (-). DO NOT
allow clamps at opposite end of cables to touch, elec-
Fig. 5 Hoisting and Jacking Points
1 - DRIVE ON LIFT
2 - FRAME CONTACT LIFT (SINGLE POST)
2 - CHASSIS LIFT (DUAL POST)
2 - OUTBOARD LIFT (DUAL LIFT)
2 - FLOOR JACK
0 - 14 LUBRICATION & MAINTENANCE
PT