ChronTrol XT Series, User Manual, Page: 38 / 51

XT Series Timer ChronTrol
36 User's Guide
Changing Program Entries
To change a program, use the setting procedure outlined in the section
Program Review above. As the value for each parameter displays (control
assignments, on and off times and dates, cycle length, day omission), type in
the new value followed by
ENTER
or followed by the key corresponding to
the next parameter to be changed (if more than one parameter is to be
changed). Press
ENTER
followed by
TIME
to return to the Time of Day
display when you are finished.
NOTE : If you begin to change the value of a parameter by
mistake, pressing the parameter key again restores
the original value.
Deleting Program Entries
Follow the procedure outlined in the section Program Review . As the value
for each parameter you want to delete is displayed (control assignments, on
and off times and dates or interval length, cycle length, day omission), press
CLEAR
followed by
ENTER
. To remove a program from memory entirely,
continue to clear the remaining values.
Factory Settings (Defaults)
When you first install ChronTrol’s XT timer, the following parameters are in
effect:
•
All programs are active
•
All inputs are enabled (applies to XT’s equipped with N8 Input Option)
•
Date is set to 30199 (March 1, 1999)
•
Time is set at 12:00:00 a.m. and counting.
•
No Lock Code is set or active