XT Series Timer
ChronTrol
22
User's Guide
Set a program as follows:
Step 1 - Assign Program Number
Select the number for a new program as follows:
1.
Press
ENTER
.
E–
displays.
2.
Type the number of the program you want to set.
E–
n
displays, where
n
is the number you put in.
NOTE
: If you skip this step, ChronTrol will
automatically assign the next available program number.
3.
Press
ENTER
.
P–
n
displays, where
n
is the number of the program,
along with its status. A dash (
–
) displays if no program is available.
Step 2 - Specify Control Assignments
Decide if you want to switch circuits ON or OFF, enable or disable inputs, or
activate or deactivate other programs.
Circuits -
If you want this program to switch any of the AC outlets or dry-
contact outputs ON or OFF, assign them to the program as follows:
1.
Press
CIRCUIT
.
C–
displays.
2.
Type the number of the circuit.
C–
n
displays, where
n
is the number of
the circuit specified.
Repeat this procedure until all the circuits are assigned.
Program Assignment -
If you want this program to activate or de-
activate other programs, assign them as follows:
1.
Press
PROGRAM
.
P–
displays in the window.
2.
Type the program number.
P–
n
displays, where
n
is the number of the
program specified.
Repeat the above procedure until all the programs to be activated or de-
activated by this program are assigned.
Input Assignment -
If you want this program to enable or disable any of
the inputs, assign them as follows:
1.
Press
INPUT
.
– –
displays.
2.
Type the number of the input.
– –
n
displays, where
n
is the number of
the input specified.
Repeat this procedure until all the inputs to be enabled or disabled by this
program are assigned.
Summary of Contents for XT Series
Page 1: ......