Christopeit Sport 2001, Assembly And Exercise Instructions

Page: 21 / 60

21
GB
1. Cleaning
Use only a less wet cloth for cleaning. Caution: Never use benzene, thinner or other aggressive cleaning agents for surface cleaning as this dam -
age caused. The device is only for private home use and for use suitable indoors. Keep the unit clean and moisture from the device.
2. Storage
Push the saddle slide toward the handlebar and the seat support tube as deeply as possible into the frame. Choose a dry storage in-house and
put some spray oil to the pedal bearings left and right, to the thread of the handlebar bolt, and on the thread of the quick release for saddle sup -
port. Cover the bike to protect it from being discolor by any sunlight and dirty through dust.
3. Checks
We recommend every 50 hours to review the screw connections for tightness, which were prepared in the assembly. Every 100 operating hours,
you should put some spray oil at the pedal bearings left and right, to the thread of the handlebar bolt and to the thread of quick release for sad -
dle support.
CLEANING, CHECKS AND STORAGE
Training area in mm
(for home trainer and user)
Free area in mm
(Training area and security area
(rotating 60cm))
If you cannot solve the problem with the following information, please contact the authorized service center.
TROUBLESHOOTING
Problem Possible Cause Solution
Computer does not switch on
after start cycling.
Generator voltage missing base on not
well plugged connection.
Check the plug connections at computer and inside of handlebar
support. Take off the left cover if necessary and check the plug
connections there.
Computer is not counting data
and do not switch on after start
cycling.
Sensor impulse missing base on not well
plugged connection
Check the plug connections at computer and inside of handle -
bar support.
Computer is not counting data
and do not switch on after start
cycling.
Sensor impulse missing base on not cor -
rect position of sensor.
Take off the cover and check the distance between magnet and
Sensor. The magnet at turning belt wheel should have only less
than < 5mm distance against the sensor position.
No pulse value Pulse cable is not plugged in. Check the separately pulse cable is well connected with compu -
ter.
No pulse value Pulse sensors not well connected Screw out the screw for pulse measurement and check if plugs
are well connected and no damage at pulse cable.