Christie TVC-1211, User Manual, Page: 28 / 46

3-8 TVC-1211 User Manual
020-100769-01 Rev. 4 (05-2012)
Section 3: Connecting the Controller
3.5.3 No DVI Signal
If you do not see output on any of the display devices, it is possible there is a problem with the EDID. For
example, if the system detects different resolutions, as reported by EDID, it automatically switches to analog
output.
1. Power down the controller. For details, refer to 3.8 Powering ON/
OFF, on page 3-9 .
2. Connect an analog multi-sync monitor to the Display 1 connector.
3. Power up the controller and confirm the configuration is correct.
NOTE:
The video overlay created when a MediaManager
window is opened is maintained for some time after the
MediaManager window is closed. Changing the resolution while
this overlay is active can cause unpredictable behavior. Restart
the system before changing the resolution
.
4. Check the Force DVI checkbox.
5. Power down the controller.
6. Reconnect the DVI cable for Display 1.
7. Power up the display devices and the controller.
NOTE:
If you still do not see output on the DVI displays, contact
Christie Technical Support.
3.6 Connecting Peripheral Devices
1. Connect the keyboard and mouse to the USB ports on the back of the expansion chassis.
2. Connect CAT5 Ethernet cable(s). This step is only required if you are connecting to 1 or more networks.
NOTE:
ILO port is not supported.
3. Connect any peripheral devices, such as USB or serial components to the appropriate connectors on the
rear and/or front panel.