Christie Solaria One, Service Manual

Page: 73 / 88

Section 5: Troubleshooting
Solaria One/Solaria One
+
Service Manual 5-3
020-101039-02 Rev. 1 (06-2013)
• Make sure the FIPS LED on the Christie IMB is green. If the FIPS LED is red, put the projector in standby
mode and then full power mode. If the FIPS LED remains red, contact Christie support. For contact informa-
tion for your region, see the back cover of this document.
• Make sure the battery is charged and that the Christie IMB keys and certificate are present.
• Make sure the Christie IMB is selected as the input device for the channel:
• Tap Menu > Channel Setup .
• Select a channel in the Channel Name list.
• Tap Config 1 in the left pane.
• Select IMB-Internal in the Input list.
• Tap Menu and then tap the IMB icon in the status bar at the bottom of the TPC. Make sure there are no crit-
ical alarms preventing the Christie IMB from operating.
Flicker, Shadows, or Dimness
• Ensure the douser is open.
• Align the lamp.
• Tap
Menu > Advanced Setup > LampPower/LiteLOC™ Setup . Monitor the Power % field to determine
if the power is consistent or if it varies. Increase the lamp power. Lamps which are near end of service may
not operate reliably at a lower power setting.
• Fold mirror misalignment. Contact your Christie accredited service technician to resolve the issue.
• Integrator rod misalignment. Contact your Christie accredited service technician to resolve the issue.
Blank Screen, No Display of Cinema Image
• Ensure the lens cap is not on either end of the lens.
• Ensure the lamp is
ON .
• Confirm all power connections are still OK.
• Ensure the douser is
OPEN by verifying the state of the douser on Main panel.
• Ensure any test pattern other than the full black test pattern displays properly.
• Verify the correct display file is selected.
• For cinema connections, verify the correct port is selected.
Severe Motion Artifacts
Verify if there is a synchronization problem with reversed 3-2 pull-down in the 60Hz-to-24Hz film-to digital
conversion and correct it at the source.
Image Appears Vertically Stretched or Squeezed into Center of Screen
Open the Source File Setup window and verify the resolution and aspect ratio settings. Open the Screen File
Setup window and verify the lens factor settings
Inaccurate Display Colors
Tap Menu > Channel Setup . Tap Config 1 in the left pane and verify the correct value is selected in the PCF
list. Tap Config 2 in the left pane and verify the correct value is selected in the Color Space field.