Christie MIRAGE DS+10K-M, Setup Manual

Page: 14 / 72

2-2 Mirage M Series Setup Guide
020-100592-02 Rev. 1 (11-2010)
Section 2: Installation and Setup
2. Align the lens interface plate with the lens mount. Align the lens electrical connector with the mating
connector on the lens mount. Fully insert the assembly straight into the lens mount opening without
turning. Press using your hand as shown in
Figure 2-2 .
NOTE:
When installing the lens, ensure that the
lens is not inserted at an angle, as this can cause damage.
3. Remove the front lens cap.
4. While holding the lens flat against the lens mount, rotate the lens clamp clockwise to lock the lens
assembly in place. See Figure 2-3 & Figure 2-4 .
5. For added stability such as motion applications, fasten the security screws provided with the lens-mount.
NOTE:
There are two types of lens plate models. See Figure 2-5 & Figure 2-6 .
F
IGURE
2-2 L
ENS
P
LACEMENT
F
IGURE
2-3 F
IGURE
2-4