Christie MIRAGE DS+10K-M, Setup Manual

Page: 60 / 72

6-6 Mirage M Series Setup Guide
020-100592-02 Rev. 1 (11-2010)
Section 6: Specifications
6.2.10 Lamps
6.2.11 Status LED
6.2.12 Electronics/SW
Dual Mercury lamp system Lamps are accessed from side of projector
Lamps are individually swappable while the
projector is running
Status LED’s Located at back of projector
LED STATES
Lamp 1, Lamp 2 Off – Lamps are off
Yellow – Lamp time has expired and lamp should be replaced
Green – Lamp is on and operating correctly
Flashing red – Lamp has malfunctioned
Power Off – AC power is off
Yellow – AC is present but projector is in standby
Green – Projector is powered up and operating normally
Flashing green/yellow – Projector communication in progress
Flashing red – Error has occurred. Details are displayed on the status display
Shutter Green – shutter is open
Yellow – shutter is closed
FEATURE COMMENTS
Video Format Re-Sizing All video formats can be resized to fill screen either horizontally or
vertically while maintaining aspect ratio
Picture in Picture
Seamless Switching
Built-in 2D keystone and geometry correction
Auto-scaling
Auto-de interlacing
Edge blending
Warping
Tiling (support for up to 3x3 arrays)
Blanking and Image positioning
Brightness, contrast, color, and uniformity
user settable control
Image orientation Can display image front/rear, normal/inverted (ceiling)
Electronics HW access All accessible electronics are mounted from the back of the projector
Number of option cards 6 user inter-changeable – hot swappable
Number of processor cards 2 user inter-changeable
Number of option slots 4, located at back of projector for option cards; 1, located at back of
projector for processor card
Native format adjustment Optional global aspect ratio setting can be set for projector allowing for
automatic scaling of all input images to required output format
Arbitrary Gamma User definable gamma curves