Christie MIRAGE DS+10K-M, Setup Manual

Page: 34 / 72

3-12 Mirage M Series Setup Guide
020-100592-02 Rev. 1 (11-2010)
Section 3: Operation
Edit numerical values:
Enter numbers directly from the keypad to specify numbers representing projectors channels (source setups),
or slots.
As each digit is entered, it is inserted on the right of the field, and the numbers already in the field are
shifted on the left. The channel numbers are defined with two digits—for example, if you enter only a single
digit (such as “7”) for a channel number, the channel will automatically be defined as “07”.
Enter “07” to utilize this channel.
If you press any non-numbered key, the number entered up to that point is
accepted and updated as the new value. Press
E
XIT
to cancel editing of numerical values.
3.3 Alarm Conditions
An alarm condition consists of a
message that is on the LCD display
located beside the built-in keypad, see
Figure 3-11 .
There are two types of alarm conditions:
• Warning Alarm
• Critical Alarm
A warning alarm is shown when an error
or a non-optimal condition has occurred. That will generally not prevent the projector from operating. An
example is when a temperature is slightly elevated.
A critical alarm is shown when a condition occurs that could prevent the projector from operating and could
cause damage to the projector. This may cause the projector to shut down automatically. An example would be
a fan not running.
Both alarm types display:
• the item of alarm
• the status of the item
The item of the alarm can be either physical, i.e. fan or sensor, or the alarm can be a software issue, i.e. lamp
driver. The LCD displays the status of the item and its units; if applicable. If the status of the item is out of
normal range an alarm is created. When the status of the item is within normal range the alarm will clear.
NOTES: 1)
When an alarm is displayed in the LCD display, the built-in keypad is disabled. To confirm the
alarm, press the OK soft key to enable the built-in keypad . 2) The alarm condition can also be viewed using
the remote in the read only Status menu.
F
IGURE
3-11 E
XAMPLE OF
A
LARM
C
ONDITION